Springwood (South East Queensland) 2016 hourly...

Period of operation: 1 January to 31 December 2016
Site location: Latitude: -27.6125; Longitude: 153.1356
AS/NZS 3580.1.1 site classification: Neighbourhood
AS/NZS 3580.1.1 compliance (pollutants): Complies, except for:

• Trees above height of PM10/PM2.5 inlets within 5 metres south and west of the monitoring site.

AS/NZS 3580.14 compliance (meteorology): Complies, except for:

• Located below the upper level of a ridge running roughly northwest-southeast.
• Trees within 10 metres of the monitoring site (below height of wind sensor).
• Temperature, relative humidity and barometric pressure sensors located 3 metres above ground level.

Wind: Ultrasonic sensor

• Height above ground level: 10 metres.
• The wind direction sensor is aligned to magnetic north. The reported wind direction is referenced to true north by application of a magnetic declination correction of +11 degrees to the sensor output value.

Temperature: Capacitive ceramic sensor
Relative humidity (from 25 February): Capacitive thin film polymer sensor
Barometric pressure (from 25 February): Capacitive silicon sensor

Ozone, nitric oxide, nitrogen dioxide, sulfur dioxide, benzene, toluene, xylenes (total) and formaldehyde: Differential Optical Absorption Spectroscopy (DOAS) analyser operated in accordance with AS/NZS 3580.15

• Values are average concentrations over 250 metre light path running east-west from (-27.6117, 153.1382) to (-27.6125, 153.1359).
• Instrument output offset and/or scaled based on instrument calibration data.

PM10 (until 15 February): Tapered Element Oscillating Balance (TEOM) Model 1400AB operated in accordance with AS 3580.9.8

• Measurement values do not compensate for loss of semi-volatile components from the collected particulate matter.
• Instrument output values are adjusted in accordance with US EPA equivalence designation method EQPM-1090-079 requirements (scaled by 1.03, offset by +3.0).
• After adjustment, negative hourly PM10 concentrations less than -0.5 µg/m^3 are removed and concentrations between -0.5 µg/m^3 and 0.0 µg/m^3 are set to 0.0 µg/m^3.

PM2.5 (until 15 February): Tapered Element Oscillating Balance (TEOM) Model 1400AB operated in accordance with AS 3580.9.8

• Measurement values do not compensate for loss of semi-volatile components from the collected particulate matter.
• Reported values are unadjusted instrument output values as per the requirements of the Air NEPM Technical Paper on Monitoring for Particles as PM2.5.
• Negative hourly PM2.5 concentrations less than -0.5 µg/m^3 are removed and concentrations between -0.5 µg/m^3 and 0.0 µg/m^3 are set to 0.0 µg/m^3.

PM10/PM2.5 (from 25 February): Dichotomous Tapered Element Oscillating Balance (TEOM) Model 1405-DF fitted with Filter Dynamics Measurement System (FDMS) operated in accordance with AS/NZS 3580.9.13

• The FDMS system compensates for the loss of semi-volatile components from the collected particulate matter.
• Reported concentrations are uncorrected instrument output values.
• The reported PM10 and PM2.5 concentrations are calculated from running 1-hour average concentrations updated at six minute intervals.
• Negative hourly PM10/PM2.5 concentrations down to -5 µg/m^3 resulting from instrument noise at low particle concentrations are reported.